PC ProductsPC-Super Epoxy Adhesive Paste, Two-Part 1 oz Double Syringe, Translucent 16619

This is my new go to product for many repairs. The use of the syringes to dispense the material means I never have any product that is wasted by one of those old style tin tubes. I can easily measure out the exact proportions of hardner and resin so that the epoxy sets up perfectly every time. While it is a little more expensive, I have had zero waste, since I started using PC Super Epoxy. I recently used it on the wood floor 2x4 framing for a small shed. The outside of the 2x4 had become checked and cracked after 30 years exposed to the weather. I sanded down the 2x4 and cleaned up any loose pieces of wood fiber. I mixed up, in back to back applications, several syringes of PC Super Epoxy and coated the exposed surface of the 2x4. The PC Super Epoxy went on smoother and stayed where I put it far better than the other very popular name brand (JB Weld). I had already tried to do the same job in another section with JB Weld and it was hard to apply and get to stay in place and therefore it looked sloppy and did not have a good finish. The PC Super Epoxy works like no other epoxy I have ever used. It did not sag or run but instead clung to the wood and made a smooth seamless surface. After it hardened, I sanded it lightly and finished with primer and paint and it looked better then new. This product is amazing and i have used it several repairs and really love the results achieved.

So, having used epoxy a lot over the years, I am familiar with using it from tubes, bottles and syringes. Most of the syringes just plain suck! They might work fine if you are squirting out a large amount, but they want to push out unevenly to start and you get more or less of each component when you are dispensing just a little. Plus, they do not seal well. This product surprised me: The product flows out perfectly evenly; the screw on syringe cap goes on effortlessly, and STAYS on!The adhesive is good. It is creamy rather than thin/liquidy, so that is either a pro or con, depending upon what you need. The workable time is accurate (15 mins) and you should note that the cure time is also accurate, meaning it is NOT a fast cure, but take several hours before it is fully cured...that can be an issue depending upon the task!

Pulled a wall out in the basement. There were 1/4 on deep holes left in the floor from the nail/anchor's left. Used this quick setting epoxy to fill the openings and and level off the floor. After 2 days for setting, sanded and prepped the area for paint. Turned out perfectly and would use this product again without hesitation. Two points you need to know. 1. Wear gloves and 2. Mix only what you can use within a 10 minute period because it sets up pretty quickly. For the price a great product.

Easy to use. Unfortunately not as good as PC7. Bond can be broken where as PC7 held.

Works well all... epoxies from this company are effective. Good..can qounnt on quality..results...

I followed the YouTube video instructions for using this to repair swim fins using a fiberglass patch. The fiberglass patch failed miserably and honestly I was skeptical of the recommendation to use fiberglass near skin in the first place. I was able to easily peel off the fiberglass patches. Next I buffed the surface and reapplied the epoxy without the patch. Using it without the patch seems to have made a much stronger and better repair. Only time will tell as I have to wait another week for the pool to reopen and I can test the fin repair in the pool. I only gave 3 stars as I can’t test the repair just yet.Denatured alcohol was recommended in the video but I did not have that. I used isopropyl instead which may have weakened the bond of the first patch. I definitely suggest having isopropyl handy to get this off the skin or any other surface area before it dries.

Fast service, just what I wanted

Wear gloves. It can get messy.