BRAVO COMPANY BCM Gunfighter Trigger Guard

Shipped fast and as described. Very easy to install.One tip for anyone swapping out their trigger guard is to keep the original roll pin. That way you know it fits.

If you wear gloves while handling your AR, and I mean thick winter gloves, then this is a must-have. Even just for regular shooting gloves, this is a handy product. It saves you having to search for the pin to release the trigger guard bottom, unless you are wearing ECW mittens. Good fit. Dropped right into two Minuteman Armory carbines, a Bushmaster, and a Ruger SR-556. Easy installation. Done in a minute or two per gun. Polymer construction, which suits the purpose fine. Good value.

I bought this to replace a standard (mil spec) trigger guard. The pin which came with it drove in nicely with a 1/8th” punch, but the screw that this product utilizes instead of a detent was not quite as sturdy-feeling as I imagined it would be as they’re made by one of the best companies in AR-15 world. I would like to have seen either a detent or a more reliable fastening system.

I got this for the new AR build I was doing and it looked like it was going to be a perfect fit for my Diamondback but it is a little short on both sides the one advantage that it has as it came with a new roll pin which was a lot easier to put in the original stock one. The other side came with the Allen screw which was a little difficult to get in being that it was a little short but I made it work if it would have been a perfect fit I would have gave it 5 stars but it does its job

Bad Ass! Looks sharp, if looks could kill. Perfect continuous arc. Ready for battle! Well done. Comes with new roll pin and set screw. You will need a 1/16" allen wrench.

Excellent product. Exactly what I was looking for my AR-15. It really sets it off. Thanks again!

It's a good trigger guard. Simple to install, stays put, and is roomy enough to fit a mil spec trigger, or in my case a CMC/Lantac flat trigger and still have room for gloves.

Put this into an Aero Precision Gen 2 lower and it fits perfectly. Includes the roll pin and allen screw so no need for extra hardware. My Ergogrip came with a rubber bit to fill the gap between the grip and trigger guard but this fits flush already so theres no need for it. My first purchase from BCM but fit and finish from little stuff like this means the big stuff will be even better.